Bronco Newbe
New member
Recently purchased a 96 Bronco. Interior is in pretty good condition. However, am in need of rear side panels and rear seatbelts. Having hard time finding these parts. Can anyone provide any insight?
Rear side Panels and rear seatbelts
- Thread starter Bronco Newbe
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Seabronc
New member
Welcome to the Zone > . With the side panel; and rear seat belts, you could use ones from any FSB from 80 - 96. Your best bet is to look around at local friendly Auto Recyclers. You will need a large Torx bit, I believe it is around a T55 or T60 to get the rear seat belts out, the side panels should only require a Philips bit and the removal of the trim pieces around it.
Good luck,
/emoticons/[email protected] 2x" width="20" height="20" />
Good luck,
/emoticons/[email protected] 2x" width="20" height="20" />maddogv21
New member
If you want to buy new, LMC truck sells all that stuff to.....
