69Broncovirgin
New member
- Joined
- Jun 2, 2004
- Messages
- 21
- Reaction score
- 2
Anybody have opinions on the best way to covert to electronic ignition? ie Parts, Brands, balance of performance and cost.
'69 302 Electronic Ignition Conversion
- Thread starter 69Broncovirgin
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Broncoholics
Broncoholics
I went with Petronix Ignition is the way to go. Easier start up and betting running with a bit more power from what I felt. The kit is $80-100 I believe.
69Broncovirgin
New member
- Joined
- Jun 2, 2004
- Messages
- 21
- Reaction score
- 2
Thanks. I went with the Ignitor II kit. It's on the way. When you installed the kit, did you also install a new coil? With this kit, is the ballast resistor required, or can you just run a high performance coil?
STLKIKN
New member
On my 289, I installed the provided parts. Set the gap with the supplied "tool", checked the timing, and that was it.
The Ignitor II instructions show you how to wire with or without the ballast.
The Ignitor II instructions show you how to wire with or without the ballast.
Last edited by a moderator:
broncosurfer66
New member
- Joined
- Aug 12, 2004
- Messages
- 2
- Reaction score
- 0
Ive got a 66 with a 67 289. I went with the Davis Unified Ignition (DUI). Give them a call tell em what you got and whats in it. They test it and send the entir unit ready to drop in. All the components are in the distributor. Nothiing to mount and clutter your engine compartment. All you have to do is run 12v to it. Awesome product. About $325.
Similar threads
Members online
No members online now.
Latest posts
-
-
-
-
3 dangers I found out working on my 78 bronco--and maybe yours too
- Latest: 79' Buckin Bronco
