turing lights

[bigchris2005]

ok i have a 96 ford bronco with a 302. the problem i am having right now it the turning lights not working at all i have running, brake, and hazard lights but no turning lights. i have check all the bulbs change the fuses,i just change the switch tonight still not working now i am at a lost. so i need some help.

thanks

 

[Bronc76]

Have you checked for a short circuit or bad ground?

 

[BroncoJoe19]

None are working... front or back? If so, I'd suspect the flasher. Its probably in or near the under the dash fuse box.

 

[miesk5]

yo, I agree with my good buddy, Joe.

and here is one of the WWW's best troubleshooting pages on turn signals in General;TROUBLESHOOTING BASIC TURN SIGNAL AND FLASHER PROBLEMS

 

[bigchris2005]

well i havent given that a thought because the hazards lights are working i myself cant see the hazards working and not the turn signal. that is why i havent given it any thought as far as the flasher.

also they are not working both front and back. but like i said before the hazzards light do work all around i havent check for a bad ground yet or anything like that. i might be a day or 2 befor i get a chance to do it i live here in northern indiana we it is a tid bit cold out right now with snow. so since i dont have a nice place to put it inside and work on it it will be a couple of days

 

[miesk5]

ok, I missed what you wrote about the hazards, sorry; try this next;

Turn, High & Low Headlight Dimmer, Flash-to-Pass, Hazard, & Brake Light ckt though the Multifunction Switch (MFS) Testing & Wiring Diagram in 92-96

the MLS Sw has 2 connectors; so in this test the top conn is disconnected and the bottom con is left in-place

 

[bigchris2005]

well i havent given that a thought because the hazards lights are working i myself cant see the hazards working and not the turn signal. that is why i havent given it any thought as far as the flasher.

also they are not working both front and back. but like i said before the hazzards light do work all around i havent check for a bad ground yet or anything like that. i might be a day or 2 before i get a chance to do it i live here in northern indiana we it is a tid bit cold out right now with snow. so since i dont have a nice place to put it inside and work on it it will be a couple of days

 

[bigchris2005]

ok, I missed what you wrote about the hazards, sorry; try this next;

Turn, High & Low Headlight Dimmer, Flash-to-Pass, Hazard, & Brake Light ckt though the Multifunction Switch (MFS) Testing & Wiring Diagram in 92-96

the MLS Sw has 2 connectors; so in this test the top conn is disconnected and the bottom con is left in-place

i have already replace the Multifunction switch and it is still doing this thus i am at a lost