Trans and transfer

[Mudmagnet63]

Looks like I'm going to go ahead and replace trans and transfer. both are leaking like a seive and the tranny is making a noise in 2 & 3 gears.I have shopped all the sites does anyone have any suggestions on where to buy the pair of these. I have come across them for about $500 with a $100 dollar core I also found one place for $585 with no core so I wont have shipping costs going back. If you have bought from someone in the last year I would appreciate some input.

Thanks

Mud

 

[Bully Bob]

Hay Mud..., put your "locaton" in your profile.... it helps with "where to buy" questions.

I can tell you this.., lock your trannie in 1st gear prior to removing so as to prevent the output shaft un-caged roller bearings fr. droping into case.

ALSO... the same thing goes for the transfer....seperating it fr. the adaptor will allow bearings to drop into case.

 

[Mudmagnet63]

Uncaged any bearings dont sound like much fun. My uncle runs a trannie shop that can do the work but I cannot pin him down on a price. The trannie sounds like a bearing is going out. No problems with the transfer, it may just need seals and cleaned up. I think I may push him a little harder for a ballark price. Having all the right equipment sure helps when doing a trans swap. I have heard the T-20 is a great transfer case.

Mud.

 

[69bronc347]

man guy, i just threw my 3spd away, worked perfectly fine, i figured nobody wants those, your better off doing a swap anyway, i go with a 4 or 5 speed, bronco graveyard sells a tcase reseal kit for like 40 bucks, they say the dana 20 hold 500flb of torque reliably