I have a 1982 full size Bronco. I'm wondering if the bucking bronco emblem sold at Jeff's Bronco Graveyard will fit into the holes already drilled between the door and rear top...originally contained an XLT emblem? Is the bucking bronco pinned or does it just glue onto the metal?
bucking bronco emblem
- Thread starter mikearie
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The pair of "buckin' broncos" I have from a used early bronco has pins that are 3" apart. I am planning to put them on the fenders by the Bronco emblem. Now you got me thinking, they might look awesome on the B-pillar!
The pins come out the same side on both, so you will have one coming and one going! 
) YEs, they will be opposite of each other, in other words.
) YEs, they will be opposite of each other, in other words.
Seabronc
New member
I've plucked a few of them off Broncos in the bone yard and it seems to me they have a double sided sticky gasket to hold them on. You can also get trim holders like the ones for the wheel well trim that go in a predrilled hole and then when the pin is pushed in it holds the piece on. I'm pretty sure you can get them in different sizes to allow for different sized pins. Drilling would have to be pretty accurate.
Good luck,
>-
Good luck,
>-
