Looking for help on 1979 Bronco XLT Ranger with 400M /C6/ Auto.
I was out on a drive and it just started missing and would stall if throttle applied.
Carb rebuilt
New Coil
New factory Ign Control
New Distributor
New Plugs
New Ported Vac Switches
Tested an cleaned EGR - holding vacuum
Tested check valves on vacuum limes
White TVS switch , Not sure *** to test??
Engine will run strong for few miles and after it sits develops bad miss on load in gear.
Will idle fine, but when put in gear and throttle applied it will miss bad. loping like only running on a few cylinders or not getting any fuel
When cooled engine will run fine again???
This truck has been the most reliable vehicle I have owned!! till now.
Any Ideas???
I was out on a drive and it just started missing and would stall if throttle applied.
Carb rebuilt
New Coil
New factory Ign Control
New Distributor
New Plugs
New Ported Vac Switches
Tested an cleaned EGR - holding vacuum
Tested check valves on vacuum limes
White TVS switch , Not sure *** to test??
Engine will run strong for few miles and after it sits develops bad miss on load in gear.
Will idle fine, but when put in gear and throttle applied it will miss bad. loping like only running on a few cylinders or not getting any fuel
When cooled engine will run fine again???
This truck has been the most reliable vehicle I have owned!! till now.
Any Ideas???