I'm drowning

[gravelgerty]

Installed an Edelbrock 600 cfm on my 302, have a holley fuel pump (6-8)psi.

Problem is I'm flooding out all the time. Anybody had a problem with float levels with this carb out of the box? Thinking maybe needle and seat cause when I'm up to temp I have to keep it to the floor to start. Gas mileage really sucks!

 

[BLADE262US]

See if theres an adjustment on that fuel pump maybe lower the pressure a little bit . To adjust the floats in that carb you have to dissasemble it ( only good thing about a holley) read the directions carefully on how to set them. /emoticons/[email protected] 2x" width="20" height="20" />

 

[Bully Bob]

Elect. or mech. pump....??

That holley elect. req. a press. reg. :-&

I think 8psi is to high.

Although, bad carbs. do come fr. the factory.....(made in Mexico/Tiwan, etc. (