floor pans

[snow guy]

i was checking out all of the little things on my 78 when i reallized that the entire floor board was swiss cheese. theres a spot in the back on the drivers side that has droppd an inch(nice gap). now i watch alot of the truck shows and i have seen them replace the floor boards ,with a vehicle this should i replace the entire floor at once or should i do it piece by piece?

 

[Broncobill78]

It's generally best to do the whole job at once rather than piecemeal. Jeff's has the parts you need, left & right side floor pans and the rear bed floor.

http://broncograveyard.com/bronco/i-24150_...__48__x_16_.htm

http://broncograveyard.com/bronco/i-24084_...aftermarket.htm

http://broncograveyard.com/bronco/i-24086_...aftermarket.htm

 

[snow guy]

It's generally best to do the whole job at once rather than piecemeal. Jeff's has the parts you need, left & right side floor pans and the rear bed floor.
http://broncograveyard.com/bronco/i-24150_...__48__x_16_.htm

http://broncograveyard.com/bronco/i-24084_...aftermarket.htm

http://broncograveyard.com/bronco/i-24086_...aftermarket.htm

ok i understand do it all in one shot, so i have to brace off the entire inside of the truck?

 

[Justshootme84]

IF any of the support beams under the floor are rotted out, I would also repair/ replace those. The floorpan itself is quite thin.