auto to manual

[demo42bboo]

I have a 78 bronco with a C6 and a 351M. I got a donor trans from a 79 F350 2 wheel drive. I got the trans, bellhousing, clutch linkage, flywheel etc. Will the transfer case from the auto bolt up to that T18 or did they use a different transfer case for the manual transmission. I know I'm either gonna have to have driveshafts made or find another donor. Any help would be great. Thanks

 

[Bully Bob]

Hi bboo., welcome..!!!

There may be someone on here that can help with that (not me)...

However, if you call or email Wildhorses &/or Toms br. parts, they can help.

It's more likely the adaptor & input/output shaft that's an issue.

They do these mods on a daily basis. They have new & used parts on hand.

http://www.tomsbroncoparts.com (lots of good used parts)

http://www.wildhorses4x4.com (EB store but also into '78-'79)

P.S. Be sure the flywheel has the correct # of teeth & correct balance.

 

[jcm460]

Most likely I would look for a 4 wheel drive trans or else your going to have to buy a adapter and change the rear shaft. I know when i went from a borg warner to a new process 4 speed I lucked out and everything bolted together and you might luck out on your drive shfts and not have to change them do to a c6 being a shorter style trans. /emoticons/[email protected] 2x" width="20" height="20" />

 

[Bronco Paul]

I did a swap to a T-19 but they were both 4wd trannys...the oddest thing I had to swap was the power brake booster...the manual setup required different mounting brackets!

Paul.