351w Cam Specs For stock engine??

[92broncomann]

I just picked up and Edlebrock EFI Performer Intake (Off Craiglslist for about half price) B) and went ahead and got a BBK 61mm Throttle Body B) for it, and figured as long as im going to be removing the top end that id like to put a CAM in it since the timing cover is leaking a bit.

So the question is Asked;

What is a Good Cam for stock conditions?? Lift and duration are very important im just not good with the measerments for lift on a cam and what not.

So if you could fill me in on a good stock replacment cam id be very happy /emoticons/[email protected] 2x" width="20" height="20" /> /emoticons/[email protected] 2x" width="20" height="20" /> /emoticons/[email protected] 2x" width="20" height="20" />

Let me know,

Thanks alot

92BM

 

[Bronc76]

I just picked up and Edlebrock EFI Performer Intake (Off Craiglslist for about half price) B) and went ahead and got a BBK 61mm Throttle Body B) for it, and figured as long as im going to be removing the top end that id like to put a CAM in it since the timing cover is leaking a bit.
So the question is Asked;

What is a Good Cam for stock conditions?? Lift and duration are very important im just not good with the measerments for lift on a cam and what not.

So if you could fill me in on a good stock replacment cam id be very happy /emoticons/[email protected] 2x" width="20" height="20" /> /emoticons/[email protected] 2x" width="20" height="20" /> /emoticons/[email protected] 2x" width="20" height="20" />

Let me know,

Thanks alot

92BM

92B- Compcams offers a good stock replacement for probably what you are looking for.

 

[92broncomann]

Do you have the link for the CAM i should chose, or

What family of Cams do i Need Hydrolic or Mechanical?? And is it Flat Tap or Roller??

Im not to good when it comes to Cams, and i dont know if ford switched up to a roller cam this early...

Thanks

92BM

 

[92broncomann]

And which one would be the best for a daily driver and offroad usage, but mostly for horsepower and tourqe gains??

 

[92broncomann]

I think i found the right Cam for the job. XE254H, from Comp Cams. Anyone have any experience with this cam if its a good choice or not??

thanks

92BM

 

[lobo1117]

You can use a 5.0 ** Mustang cam @ 2* adv..

yes, it is a roller cam but its S/D friendly so MAF

is not needed.. a set of 1.7 roller rockers will really

wake it up.. you can find them used on fleabay, www.corral.net

or www.nloc.net for $50 - $100.. IIRC its 226 Dur / .444 lift..

 

[92broncomann]

I made the Decision to go with Comp Cams Xtreme Energy EFI Cam Part# 35-255-5

thanks 92BM