302 motor mount measurements?

[RedDirt]

I am doing a swap from the 170 in-line to a 302 does anyone have the exact measurements for the motor mount weld in?

 

[Rons beast]

What ya working on Red?

Good chance there is just a change of mounts needed, but the good folks here need to know what that 302 is going in.

 

[RedDirt]

My 1966 bronco. I thought this just showed up in the 1066 to 1977 bronco forum sorry.

 

[Bronc76]

I think it was obvious that you were talkin about a 66-77. Assuming you are using the same t-case,(since its using the same bolt holes) and you have the tranny that you want to use with the 302, you could probably bolt tranny/302 up to t-case and install the mounts.

 

[Bully Bob]

This is not published., prob. due to the many options (trannie back). /emoticons/[email protected] 2x" width="20" height="20" />

If it were me, & going stock as 76 says.., I'd chase down another EB & take some measurements. :-B

Seems the "new" aft. mkt. frame mounts have an elongated hole & the orig. had two holes. /emoticons/[email protected] 2x" width="20" height="20" />

The measurement fr. the drivers side transfer case mount hole (in the cross-member) to the driver side eng. frame mount outer hole is 36.5 inches.

Still., I would measure another veh. /emoticons/[email protected] 2x" width="20" height="20" />

Also., check me on this., I think the mounts have a left & right., not interchangeable.

 

[RedDirt]

Hey guys here is some info I found http://cdn.wildhorses4x4.com/downloads/8041%2008-08-06.pdf dont if its just for there's but i would think it would work with any of the other companies mounts as well. Anyone want to pip in on this one?