Hello. I'm having a **** of a time ordering these parts correctly from Summit Racing. I’m changed out the Napa OEM replacement stuff I bought a few months back, because the wires were not seating on the dist. cap correctly. I have ordered a MDS#8482 cap/rotor and MSD# 8227 coil. I have received two sets of plug wires to date. A set of ford racing that fit a old style coil and a motorcraft set that will not fit securely at the MDS coil. Does anyone have any suggestions?
1996 5.8L Bronco
- Thread starter Shep
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Seabronc
New member
If the wires are pushing back off, that is because of the tight fit of wire boot. That is Good but annoying since it gives a great seal. If it is slipping back out, you are compressing the air caught inside. Use a little non-conductive silicone grease (very light, just enough to feel but not see), press the boot on while holding the edge open to let the air out.
Good luck,
>-
Good luck,
>-
