Latest activity
-
L\Bronco reacted to Jimbo26's post in the thread What Did you Do With Your Bronco Today??? with
Like.
Grazie. Was a bit concerned with the double layer of metal in that area, but luck & superior skill was on our side once again. Edit... -
Jimbo26 reacted to L\Bronco's post in the thread What Did you Do With Your Bronco Today??? with Like.
Nice work! -
L\Bronco reacted to Dadpool's post in the thread 1989 5.0 Will not go in to closed loop, bogs when accelerated, no codes with Like.
We will run tests tomorrow and report back.
-
DDadpool replied to the thread 1989 5.0 Will not go in to closed loop, bogs when accelerated, no codes.We will run tests tomorrow and report back.
-
L\Bronco replied to the thread Fuel pump working 40 psi on rail no start.Good find! Brown is EEC power, green is fuel pump. If you find one that will plug in, it should work, the color denotes the current...
-
I think that's my issue! 😕
-
-
That EEC Power Relay powers up just about every item in the EFI system, including injectors, PCM, and all your output solenoids like EGR...
-
91BroncoPickup replied to the thread Fuel pump working 40 psi on rail no start.Figures. It's the EEC relay. Controls all EFI. Well... I wonder if I can swap in another temporarily?
-
91BroncoPickup replied to the thread Fuel pump working 40 psi on rail no start.Well... I might have found something here. Brown relay has a hole burned in it... I'd assume that is a problem!
-
-
91BroncoPickup replied to the thread Fuel pump working 40 psi on rail no start.I just used the spark plug tester and it's getting spark (I also just put the new ignition coil in, so I was thinking it would get...
-
Sog119 replied to the thread 1990 EFI to Carb conversion.Hey Max, Where did you mount the control module? -
L\Bronco replied to the thread Fuel pump working 40 psi on rail no start.Hey 91, a quick check is to put a test light between ground and the green wire at the coil and crank the engine. The light should flash...
-
I didn’t break it down that far. It was running perfectly fine other than the fuel pump leaking replaced the fuel pump then after that...
-
91BroncoPickup replied to the thread Fuel pump working 40 psi on rail no start.Had a mechanic install the new fuel pump inside the tank for me about 4 months ago... They cleaned the tank, replaced with good fuel as...
