Latest activity
-
Ppaul rondelli replied to the thread Turn ....activates trans slip?.Check your third brake light. Might seem crazy .... but the ECU looks at voltage to the third brake light to see if the brakes have...
-
Ssuddenchance replied to the thread 88 5.0 backfiring and missing..Appreciate the info! I did check and the exhaust and it did fix the backfiring issue! The engine is still misfiring. I checked codes and...
-
Tiha replied to the thread Turn ....activates trans slip?.Ditto, Seen filters fall off or leak around the seal and do this. -
WHey Zalkins: Most of the time, flare on turns is low fluid level or the seal between the filter and valve body is leaking. It doesn’t...
-
L\Bronco replied to the thread Turn ....activates trans slip?.Hey Zalkins: Most of the time, flare on turns is low fluid level or the seal between the filter and valve body is leaking. It doesn’t... -
So this has been a very vague issue over the passed year. Like 3 times I've noticed either taking a right or left while pressing the... -
The offset bushings, alter camber, and caster. With the stock Dana 44, the Ford specifications are 1 to 3 degrees positive camber. I... -
Bob Smell replied to the thread Dana 44, 5-Bolt camber shims,.The offset bushings, alter camber, and caster. With the stock Dana 44, the Ford specifications are 1 to 3 degrees positive camber. I... -
That is a great idea. I was gonna say pop an O2 out and start it, or pull the EGR and start is. Let the exhaust leak and see if it runs...
-
Tiha replied to the thread 88 5.0 backfiring and missing..That is a great idea. I was gonna say pop an O2 out and start it, or pull the EGR and start is. Let the exhaust leak and see if it runs...
-
L\Bronco replied to the thread 88 5.0 backfiring and missing..Hey there sudden, welcome to the zone! That sounds like exh restriction, (maybe one side?) Does it still have cats? Hook a vacuum gauge...
-
-
Same way on the pontiac,s back in the 70.s. Put new nuts on them and they should be good to go..Then they were 58 cents each. Now...
-
muddrivermike replied to the thread Dana 44, 5-Bolt camber shims,.Dont know why nobody has replied to this. Why dont you just use the offset camber bushing that screws into the top? Those shims súçk.
-
SHey everyone, Update! Bronco is running rich! Fuel injectors are new and fuel pressure is at 33lbs and holds. Spark plugs are fouling...
-
These are older Edelbrock ones, Im putting on my roller 5.0L thats going in my 69 mustang rag. (After I polish them of course.) They are...
