Problem with automatic hub

[Slygh93]

So I had to replace my rotor and I went ahead and replaced my inner and outer wheel bearings and all the other good stuff inside and when i re assembled everything and get down to putting the last snap ring in I can't get it into the groove.. It's as if everything sits about an 1/8" to far out.. If that makes any sense at all. I've tried screwing the locking nut in farther 3-4 times but that didn't help at all. Any wisdom or advice would be great.

 

[Bully Bob]

What are we working on here...?

Some pics would help........ /

Filling in your info. pages will go a long way to getting quality help here as well.

The good news is you have the other wheel/hub to remove to find out what might be wrong.