J-shifter hole

[DATownsend]

What is the dimension of the j-shifter hole and what is the measurement from the driver side corner and back corner of the tunnel is it location?

 

[johnnyreb]

What is the dimension of the j-shifter hole and what is the measurement from the driver side corner and back corner of the tunnel is it location?

What year are you asking about?

 

[miesk5]

Yo DA,
Is this q for a 77?
And is for the C4 or 3 speed manual?

 

[DATownsend]

What year are you asking about?

1977, with a C-4

 

[DATownsend]

Yo DA,
Is this q for a 77?
And is for the C4 or 3 speed manual?

77 with a C-4

 

[DATownsend]

What year are you asking about?

1977

 

[chrlsful]

the 'J handled' is the x-fer 'stick' (only '71? on).
Many ppl imbed a pre subsumed answ in their Qs. We go around in a circle to get an answ and the problem is not 'fixed". In these cases stating the problem avoids all that.

Not sure what the case is here but state the problem 1st and folks w/experience here might supply shortcut 'correct' answrs. Possibly not as lots of ppl speak up when not really knowing...

 

[DATownsend]

the 'J handled' is the x-fer 'stick' (only '71? on).
Many ppl imbed a pre subsumed answ in their Qs. We go around in a circle to get an answ and the problem is not 'fixed". In these cases stating the problem avoids all that.

Not sure what the case is here but state the problem 1st and folks w/experience here might supply shortcut 'correct' answrs. Possibly not as lots of ppl speak up when not really knowing...

 

[DATownsend]

J- shifter was used from 1973-1977.

 

[chrlsful]

OK, & U R having what kinda problem w/it?

(Example:Re-doing floor/tunnel & can't figure where to place hole? None on the sheet metal shipped U? ...and so on...).
1) Craw under, w/x-fer in/no handle'n poke a nail/awl hole. If U
got that stuff in the catalogue pic place around puncture'n cut
out.
2) Go to the on-line bronk clubs w/'exploded view' diagrams'n
take dwn the measurements...
3) Telephone 1 ada 'typical bronk vendors' & C if U can get 1
to go out to a machine'n measure...

 

[chrlsful]

All set?