Ball joint

[silicon_bronco]

Hey all,

I have been working on my ball joints well trying to that is.

I finally got the last nut off the spindle and now I can not get the spindle off the knuckle.

any thought on how to go about this..?

Also will the drive assembly slide out of the knuckle opening after the spindle is removed?

It looks as if it is to big to fit through.

I have some pic's up on my gallery if you want to check it out..

http://broncozone.com/forums/index.php?act...album&album=222

thanks all..

 

[TX_BEAST]

try ball joint spliting fork to separate the ball joints and yes the axle should pull out after spindle in removed. /emoticons/[email protected] 2x" width="20" height="20" />

 

[silicon_bronco]

try ball joint spliting fork to separate the ball joints and yes the axle should pull out after spindle in removed. /emoticons/[email protected] 2x" width="20" height="20" />

27777[/snapback]

​

It is not the ball joints that is getting me all ****-e. The spindle is fused to the knuckle and will not come off.