[ford8624]

My broncos only problem I have is that red wire hanging on the bottom gets hot only when i turn igntion all the way over before i start it. I traced the wire it splits into another brown one that goes to solenoid and igniton control module. It runs good but the wire just stays hot almost to the point of melting but it doesnt theres no shorts anywhere else.

Attached thumbnail(s)

• 

[andre]

there two wire there did you trace both of them
bad connection check it out
youre red /green line may b ok but red look like yellow may be short
but heat up near feed sorce
is it hot when it run ??
some control module and coil will get hot because not running keep power not sending it out
if running it ok
if needed more info
like engine size auto or not
try to get wirering diagram to pin point promb

may have diagram here