Ford Bronco Zone Early Bronco Classic FullSize Broncos: Ball Joints - Ford Bronco Zone Early Bronco Classic FullSize Broncos

Jump to content

Page 1 of 1

Ball Joints

#1 User is offline   cantbecaught4 

  • It's Only Money, Right?
  • PipPipPip
  • Group: Members
  • Posts: 32
  • Joined: 30-May 09
  • Gender:Male
  • Location:Harbor Springs, MI

Posted 15 July 2010 - 06:00 PM

I am going to replace the ball joints in my 78. Does anybody know if the ball joints are going to come off with the knuckle, or if they will remain on the axle. I have seen both ways, hopefully they come off with the knuckle. Any input would be appriciated.
0

#2 User is offline   Elmo 

  • Bronco Maniac
  • PipPipPipPipPip
  • View blog
  • View gallery
  • Group: Members
  • Posts: 130
  • Joined: 02-December 08
  • Gender:Male
  • Location:Roberta Ga Dixie
  • Interests:my intrest are all over the place from cars /trucks to guns to fishing to motorcycles and four-wheelers.But my main intrest is my kids if it can involve them then I can enjoy it. If they have fun then I am having the time of my life.

Posted 15 July 2010 - 10:00 PM

If I recall they will be pressed into the axle. Usually use a large "C" clamp and an approiately sized piece of pipe to remove and re-install them. may want to borrow the tool from Autozone or the like.
http://www.supermotors.net/21604 1990 5.8L manual transfer case auto tranny six-liter tune 14*timing
0

#3 User is offline   cantbecaught4 

  • It's Only Money, Right?
  • PipPipPip
  • Group: Members
  • Posts: 32
  • Joined: 30-May 09
  • Gender:Male
  • Location:Harbor Springs, MI

Posted 19 July 2010 - 04:27 PM

Thanks for the info
0
Page 1 of 1

Fast Reply

  

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users