Jump to content


Photo

4 link a 79 bronco


1 reply to this topic

#1 clean79dirty03

clean79dirty03

    Bronco Newbie

  • Members
  • 4 posts

Posted 15 February 2010 - 08:22 AM

I'm really contemplating doing a 4 link set up front and rear on my bronco. I also wondering why i havent seen this done seems like everyones living by there 3 link?. Also looking for a place to buy my rod ends and tabs for axle?

#2 Justshootme84

Justshootme84

    Supreme Commander

  • Moderators
  • PipPipPipPipPipPipPipPip
  • 4213 posts
  • Gender:Male
  • Location:Palacios, TX
  • Interests:4wd trucks, hunting, fishing, music

Posted 16 February 2010 - 05:45 AM

Some factors I considered were COST of the parts, fabrication & engineering, and breakage on the trail. If a linkbar bends or you break a heim joint, you're not likely to get it repaired on the spot. Cage Offroad has a nice setup for the front, which most folks I've run into prefer. Not sure if they're still in business, but james Duff and perhaps some other vendors may still sell their parts.
1984 Bronco XLT, 460, C-6 AT, Dana60, Sterling 10.25", 36" GYR RT-II's on H1 rims, S&W Racecars 10-pt cage kit, PRP racing seats, tube doors, Herculiner, custom "shaker" assembly.

1988 Bronco Custom, 302 EFI, C-6 AT, Ford 8.8". parting out

1986 Bronco Custom, 300-I6, NP435 4sp, Ford 8.8", new paint

1988 F-350, 4WD, 460 EFI, C-6Dana 60, Sterling 10.25 (donor)

1978 Bronco Custom, 351M, NP435, Currie Ford 9" w/ spool

1979 F-150 4WD, 351M, C-6, 4.10 gears w/ 35" mud tires

Posted Image



Reply to this topic



  


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users