I put in a new ignition lock in my 1984 Bronco and now my signals don't work. I have checked the fuse and flasher and they are fine. The hazard flasher works fine.
Is it possiable something did not line up when I put the lock in? It does have a tilt and I think it was in the down postion when the switch went in. I don't know if this has anything to do with the problem but just trying to think of everything that could have happened. Thanks

i would check for a lose connection in the colum ? since you were messing with it you could have pulled or even cut the wires going to the turn switch. or I had the headlight switch/ connector come lose cauing lighting issues.... hope this helps

It is possible that you shorted a line when you were in there working on the switch. A diagram is attached. Check out the fuse and flasher, but more likely the fuse (fuse 5) or a connection. All connections go through the connector located on the steering column under the dash.

Good luck,

>-